News

You are here: Home » News

  • Publish Time: 2018-11-12
  • Visit: 　　

?Once a valve is installed, it is important that it is properly maintained, so that it works in an efficient manner. Poor or no maintenance of a valve can result in severe problems, leading to many obstructions in the processes for which it is being used. Therefore, it is extremely important that a valve is maintained well for better functioning and a long lasting as well as effective use.
 
Check After Receiving
After receiving a valve, a complete and thorough examination of the product should be done. There might be cases wherein damages could have taken place in transit. So, the various components of the valve are its actuator, entire body or ends, everything should be checked meticulously. In case a damaged valve is received, it should be replaced at the earliest to avoid any wastage of resources during the functioning of the valve.
 
Proper Storage
If a valve is not installed after receiving, then it must be stored in a clean and safe place. It is important to note that the storage should be done in such a way that the valve stays away from grit, dirt, etc. If possible, it should be stored in a protective cover or casing till the time it is installed.

Clean The Valve Before Installing
To ensure an uninterrupted flow of fluid, it is extremely important that the valve is cleaned and is free from all the dust particles, dirt, etc. This will not only help in the smooth functioning of the valve, but will also help in ensuring its long-term use. It is also necessary that before its installation, the valve should be completely dried out. Thus, dry air can be used for the cleaning purpose of the valve.
 
Manufacturer's Manuals
In case of any disruption in the working of a valve, you should always refer to the manufacturer's manual. This will help to ensure proper valve maintenance and can also help you sort out the minor technical glitches on your own, without the assistance of an expert.
 
Leakage Detection
Whenever you detect any leakage from the valve, you should determine its cause, and then take the necessary corrective measure. Whether the valve needs repair or replacement, it should be decided only after thoroughly inspecting the cause of the leakage and the available solutions to correct the leakage. any times, it can be fixed by tightening a nut or a bolt. The pipe connections should also be regularly checked properly after the installation.
 
So, keep these simple and basic points in mind for proper valve maintenance & to ensure its efficient working. You can also reach to your manufacturer for any help on the valve maintenance.
Previous:
Nine types of valves - working principles, pros and cons (part two)
Next:
MED VALVES will take part in the OSEA exhibition in Singapore from Nov. 27th to